1. The rib will draw attention to the extra sheet's width. Because of the sheet's width, it is possible to save money and utilize fewer metal sheets. Each sheet has 4 standardized ribs with a rib height of 20 mm and a total width of 800 mm.

​

2. It is appropriate for slopes of 3 degrees or greater. Depending on the length of the sheet and the amount of precipitation that can be supported.

​

3. The purlin must be in a plane where rainwater can be drained without interruption. The optimum purlin spacing should not exceed 1.00 m. However, it depends on the thickness of the metal sheet.

​

4. It can be used for roofing or wall panels.

​

5.It is suitable for residential houses, small factories, farm, and used as ceiling panels, etc.

​

6. It can be spliced ​​with smooth, beautiful and close joints.

​

7. It can be SPRUNG CURVED ROOFING. The minimum inverted curvature radius is 28 meters.

​

8. The installation system is BOLT TYPE.